4 GB LImit TrafficStatistics
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
4 GB LImit TrafficStatistics
Model : CPE210
Hardware Version :
Firmware Version : 2.1.6
ISP :
Hey TP-Link,
is there a time we will get correct interface counters with 64 Bit ? Now if the statistics reaches 4 GB it counts from 0 again so these values are not useable ... even in pharoscontrol the statistics are set back to 0
Anyone around here ?
Regards,
Snot
Hardware Version :
Firmware Version : 2.1.6
ISP :
Hey TP-Link,
is there a time we will get correct interface counters with 64 Bit ? Now if the statistics reaches 4 GB it counts from 0 again so these values are not useable ... even in pharoscontrol the statistics are set back to 0
Anyone around here ?
Regards,
Snot
Re:4 GB LImit TrafficStatistics
Snotmann, you're right and it is even worser: TX byte count for LAN0 overflows at 2GB, while RX count for WAN7 overflows at 4GB (firmware version 2.1.6):
(The small difference in the packet count is due to monitoring while copying data.)
That's not state of the art. I suggest you open a ticket with your local TP-Link support, since they not always monitor the user's forum. A ticket will ensure that the bug-report is sent to R&D.
(The small difference in the packet count is due to monitoring while copying data.)
That's not state of the art. I suggest you open a ticket with your local TP-Link support, since they not always monitor the user's forum. A ticket will ensure that the bug-report is sent to R&D.
༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻