TL-R480+ cant see devices on Lan via device connected to WAN Router
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-R480+ cant see devices on Lan via device connected to WAN Router
Model :
Hardware Version :
Firmware Version :
ISP :
Hi Guys, this is a bit hard to explain but my diagram says it all. Basically Network 2 is directly connected to an ASUS Broadband router.
Network 1 is connected to the TL-R480+
The TL-R480+ is connected to the ASUS router via the R480+ WAN Port1
I only have 1 cable buried in the ground connecting the R480 and the ASUS Router. There is no way to run another cable.
The ASUS Router manages the PPOE connection. but also provide DHCP to network 2
Is there anyway I can print and see devices in Network 1 from Network 2. (i did set-up a static route on the ASUS Router but this would not let me see anything past the WAN Link on the R480+.)
From Network 1 I can see all of the devices in Network 2.
Hardware Version :
Firmware Version :
ISP :
Hi Guys, this is a bit hard to explain but my diagram says it all. Basically Network 2 is directly connected to an ASUS Broadband router.
Network 1 is connected to the TL-R480+
The TL-R480+ is connected to the ASUS router via the R480+ WAN Port1
I only have 1 cable buried in the ground connecting the R480 and the ASUS Router. There is no way to run another cable.
The ASUS Router manages the PPOE connection. but also provide DHCP to network 2
Is there anyway I can print and see devices in Network 1 from Network 2. (i did set-up a static route on the ASUS Router but this would not let me see anything past the WAN Link on the R480+.)
From Network 1 I can see all of the devices in Network 2.
