Home

Forums

Stories

Knowledge Base

Business Community > Pharos Wireless Bridges > Using the CPE510 & Periodical long ping-times

< Pharos Wireless Bridges

Using the CPE510 & Periodical long ping-times

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Using the CPE510 & Periodical long ping-times

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

sunshineh

2017-09-08 04:22:54

Posts: 27

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2017-07-15

Using the CPE510 & Periodical long ping-times

2017-09-08 04:22:54

Model :

Hardware Version :

Firmware Version :

ISP :

We are using the CPE510 without security options. When I am doing a ping-test I can see, that about every 10-20 ping one or two very long ping times are coming with over 200ms. It is always the same behaviour.

How can I detect the reason for this? How could I improve it?

FritzBox7490 - CPE510 - 1.2km - CPE510 - FritBox7490 - myNotebook

5 Reply

R1D2

LV6

2017-09-08 17:50:16

Posts: 4334

Helpful: 1044

Solutions: 173

Stories: 3

Registered: 2015-12-05

Re:Using the CPE510 & Periodical long ping-times

2017-09-08 17:50:16

Which ping? From notebook to elsewhere, from notebook to Fritz!Box, from Fritz!Box to Fritz!Box or from CPE to CPE? A bit more information would be needed to answer this question.

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻

RTouris

LV3

2017-09-08 18:03:48

Posts: 183

Helpful: 12

Solutions: 0

Stories: 0

Registered: 2018-09-03

Re:Using the CPE510 & Periodical long ping-times

2017-09-08 18:03:48

While we're at it you might as well provide quality stats for your link, i.e. SNR, achieved MCS, b/g/n broadcast mode.

Now serving finite customer via f(x)=AirTime/∞ on the 5Ghz band :-/

Saber

LV1

2017-09-12 17:33:09

Posts: 9

Helpful: 2

Solutions: 0

Stories: 0

Registered: 2016-08-24

Re:Using the CPE510 & Periodical long ping-times

2017-09-12 17:33:09

Hi There,

I think that the mainly reason may be the distance between the two AP. And actually, as long as it didn't infect your normal use, I think the ping test won't need to pay too much attention.
You can pay attention to the packet lost rate of the ping reset, and if the packet lost rate is too high, then it will effect normal data transmission.
If it have influenced your normal use, I suggest you to switch to another channel or narrow the bandwith and have a try.
The CPE itself is equipped with spectrum scanning, you can run the scanning and choose a channel with the lowest noise.