Hey @LuchoM,

I would start with fresh to begin:

- Reset the Tapo Camera (Should Blink Red and Green

- Remove the Tapo Camera from the App if it is There

- Reinstall the Tapo App to clear any settings that may be interfering

- Reboot Your Phone

- Check to see if the setup network for the camera is visible from your phone's list of Wi-Fi networks, then Configure the Camera from within the Tapo App

The Slow Blinking Red Light is an indicator that the device is trying to connect to your Wi-Fi. Do you have any firewalls or protections on your network that could prevent the device from connecting? If you have an IoT or Guest Network, I would recommend trying to configure the device with these networks. I would also recommend going through the list of known networks in your phone and removing any networks for the cameras setup network.

  @LuchoM,

It looks like you have done all the steps that we recommend for troubleshooting. Lastly, I would make sure that your reset button is not stuck and is the reason it appears to have no effect. Otherwise, I would recommend getting in touch with our support teams who can help to restore the firmware to defaults or can determine if there is a fix possible. You can likely point them toward this thread so you do not have restate everything that you have done. I would make sure to mention that your reset button is not causing anything and that the setup wi-fi cannot be seen.