@jumbo777 Ok, I figured it out. The way I did it, I installed all the smart switches (12 total) and restored electrical power to the house. Next, I verified that each of the 12 smart switches were ready to configure by checking the light was blinking green and amber. I went into the app and added device. I followed all of the prompts and when it directed me to go to the device's Wi-Fi, I chose one of the 12 listed. I continued and named it "1". When it was all set up, I toggled the switch that was named "1", until I heard the click from the switch (and/or saw the light turn off and on). I went to the switch to verify the green and amber light was not on and blinking and that it was functioning properly. After that, I went into the settings and named the device (example, "living room"). I repeated for the remaining devices by naming them "1" while configuring and renaming the specific room after setup. I have all devices linked to Alexa and she picked it up right away. Viola!