@Frostbyte You do have grounds, they are the wires with the smaller wire nut at the bottom of the picture.

The 3 white wires with the larger wire nut at the top of the picture is your neutral.

@B.Will Thank you B,Will.

Ohh....I didn't know those were grounds. I always wondered why extra wires were in the boxes with a wire nuts on them, I always assumed they were the main wires or something. I was always afraid to even mess with them.  I enclosed another photo of the existing two old switches. I assume I can cross the black wires from one HS200 to the second HS200?

 Thanks again! :)

@B.Will   

Sounds good, thank you so much! . I'll try and tackle it tomorrow or this week sometime. I will let ya know. I am glad they have this forum and good folks like yourself to help. Thanks again!

@B.Will I installed both switches as per your instructions and it went smooth and flawless. Thank you again! I could never have done this without your help.  I did them both in less than 30 minutes.

Only have a minor concern (hope it's minor), is on the  wire that leads from the box that feeds the jumper, in the middle of the cable is a bare wire that looped around the screw on one of the old switches. I put electrical tape around the bare loop, if that is ok?  The box was sort of cramped for space but everything fit in. I attached all the wire nuts to all of the wires very snuggly and as tight as I could turn them. The phone app works fine, and very fast.

Thanks again, will.... much appreciated.

@Frostbyte Your Welcome

Glad to be of help.

2 or 3 wraps of tape is good.

@B.Will Update..everything's working good after a week and a belated thank you on the tape!

@Frostbyte Your Welcome

@Bethel.8009 Yes, I think most of the switches in my house are done that way. It didn't seem right to me they were done like that, but I dont know electrical so assumed it was done correctly.. I will have to do like you mentioned when I return home. Will the tape be ok for the time being, like a week or two as long as its  not a fire hazard? Or should I avoid turning on that light with my phone?

I was going to ask why the neutral and ground wires were not used in the first place, instead they were tied off and stashed behind the switch as shown in my photo? Thank you.