Bulbs/Switches/Plugs Do not reconnect after losing power

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Bulbs/Switches/Plugs Do not reconnect after losing power

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Bulbs/Switches/Plugs Do not reconnect after losing power
Bulbs/Switches/Plugs Do not reconnect after losing power
2019-06-30 19:42:08
Model: LB110  
Hardware Version: V2
Firmware Version:

I have switches, plugs, bulbs, spots... and every time the power goes out, they all power on 100% full bright no matter what the last setting was. THEN I have to do the whole reset process. THIS IS A PAIN IN THE BUTT

TP-LINK!!!  I saw other threads but did not see an answer. Does anyone have any idea if this is fixable?!

  0      
  0      
#1
Options
1 Reply
Re:Bulbs/Switches/Plugs Do not reconnect after losing power
2019-07-01 17:54:14

@JayBo 

 

If you tap on the bulb, then the gear on the top right, there a menu for "On from Power Source". If you set that to Last "ON" State then when the light comes back on, it will be 100%, but then adjust to its last on state, in which if it was 100% when it was last on that is when it will be. You can also choose other preset values so instead of being the last "ON" state, you can have the bulb be set tp 25%.

 

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 1078

Replies: 1

Related Articles