ManuelArnold wrote

Model :

Hardware Version :

Firmware Version :

ISP :
 

NC200 wireless not working after power down. Update not working.

Model :

Hardware Version : Not Clear

Firmware Version :

ISP :

NC200 installed and working with wireless router.
I need the camera on an other location and need to disconnect the power.
After connecting again the wireless connection is lost. Router signal is enough.
I use wireless because it is too far away for a cable.
Do I something wrong or is this not possible?

You could use the tpCamera app to set up the camera at the remote location so it doesn't need to power down.