1. Is there a command option available on the smart switches that will allow one to FLASH the lights? I want to be able to put the switch into an "ALARM" mode, whereby I can tell the switch to flash (ON/OFF Continuously until I send a command to make it stop). My use case is I have a camera system connected via the python-kasa integration which allows the camera software to trigger the light switch on or off which works fine, but I would like to flash the lights until I tell it to stop. I can write a loop function to do this but would be far more elegant if the switch firmware supported a flash command. Can this be added to a future firmware release if it is not supported now?