Tapo P110M can't connect to wifi
When connectin smart plug into the router network it works correctly. But I have 3 AP in my home and connecting to them smart plug just can't connect to the network. I tried direct connection to the router, smartphone hotspot and connection to the router with AP mode and only the last one not working. This is huge problem for me because I want to have plug in room covered by AP only.
I have 4 Tapo bulbs, 2 Tapo cameras and I have no issues with them. Only with the plug.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@Wayne-TP i've done both. Still same issue. I find out te issue is not related to the AP but the repeater re305. When I switched to the AP it start working but the AP is placed too far from the plug so sometimes plug is not in range of AP. When connected to the repeater it is not working at all. I can't understand the issue and event after the reset repeater to the factory settings I can't login to the admin panel of repeater... I think I need to change the repeater to the C64 AP 😛
- Copy Link
- Report Inappropriate Content
What is the encryption method set on the AP? Do the wireless SSID and password contain special characters? What is the length?
Please note that Tapo P110M supports 2.4GHz WiFi in IEEE 802.11b/g/n only.
| NETWORK | |
|---|---|
| Protocol | IEEE 802.11b/g/n, Bluetooth (for setup only) |
| Wireless Type | 2.4 GHz WiFi Only |
- Copy Link
- Report Inappropriate Content
Model: TP-Link c64
Router mode: AP
Encryption: wpa2-psk, aes
Network set to: 802.11 b/g/n
SSID: lowercase letters only
Password length: 8 characters (lowercase letters and numbers)
- Copy Link
- Report Inappropriate Content
What's the error you received during the configuration? Is the Archer C64 set to AP mode or still on router mode?
- Copy Link
- Report Inappropriate Content
@Wayne-TP hello. Something changed since last time. Device is now connected to the access point but have no connection to the TP Cloud service. It is a available locally only.
TP-link C64 is in AP mode
Main router is the Archer MR600
- Copy Link
- Report Inappropriate Content
Try to reboot all three devices, router, ap, and the camera.
Change router DNS to 8.8.8.8 and 8.8.4.4. E.g. How to configure Dynamic DNS on 3G/4G Wireless Router TL-MR3420 (new logo)
- Copy Link
- Report Inappropriate Content
@Wayne-TP i've done both. Still same issue. I find out te issue is not related to the AP but the repeater re305. When I switched to the AP it start working but the AP is placed too far from the plug so sometimes plug is not in range of AP. When connected to the repeater it is not working at all. I can't understand the issue and event after the reset repeater to the factory settings I can't login to the admin panel of repeater... I think I need to change the repeater to the C64 AP 😛
- Copy Link
- Report Inappropriate Content
Then that makes sense. When the WiFi signal is too weak or disappears at all, the smart plug cannot function well.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 106
Replies: 7
Voters 0
No one has voted for it yet.