T4U Plus runs at high speed not superspeed
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.T4U Plus runs at high speed not superspeed
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Recently replaced a T3U USB adapter with the T4U Plus adapter. The T3U ran as USB 3.0 (superspeed) but the T4U runs in the same port as USB 2.0 (highspeed) .
The T4U does show a speed increase over the T3U but I feel it could do more if it were recognised as USB 3.0. Is this normal behaviour or have I missed something?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
OMG shame to TP-LINK!!! Archer T4U Plus was released in 2020 !!! So many posts about this problem i have found,and they havent do anything abot that until now, no some new drivers to solv this problem!!! i have router Archer AX55 its very very good , but for now i will never buy any TP LINK WIFI USB adapters!!! Shame for them!
- Copy Link
- Report Inappropriate Content
I take my words back about TP LINK!!! I found solution. its how this device work!! Go to this device settings/properties and there where is WirelesMode: Auto (by default) choose 802.11ac only ( its WIFI 5Ghz will only work ) and then device will switch to USB 3.0 mode!! In Auto wirelsmode device chooses betweenn 2,4Ghz and 5GHZ all Wifi protokols by him self and gous to USB 2.1 or USB 3.0 !!! Sorry for may bad English!!!
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 2741
Replies: 12
Voters 0
No one has voted for it yet.