Ethernet hub with deco
Hello! I'm using the deco AC1200 (3) in my home currently. I also have a TPlink lan hub I'm attempting to use. I have the hub plugged into the main deco via Ethernet. The hub only gives Ethernet access to one device rather than the 4 it should provide Ethernet too though? Is there any way I can fix this?
thank you
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi,
Thanks for your patience.
May I know the model number of your TP-Link Lan hub?
As for the Deco AC1200, is it Deco M4?
If possible, could you please help me draw a picture of the network topology from the ISP modem to Lan hub?
Thanks a lot and wait for your reply.
- Copy Link
- Report Inappropriate Content
they are the deco M4's yes.
the tplink lan hub model number is
TL-SG1005D
I can describe the setup I have. So...
The main deco is running in router mode plugged into my original modem running in bridge mode. I then have the lan hub plugged in to the back of the main deco. I have a laptop and PS4 currently plugged into the ethernet hub. I cannot get them both to work at the same time only one or the other.
Hopefully that helps thanks!
- Copy Link
- Report Inappropriate Content
Hi, thank you for your feedback.
Could you please help me check the following details:
- Did the wireless network always work fine on the Deco M4?
- Could you please send me a picture of the ipv4 page on the Deco APP?
- Could you please help me check the IP addresses on the laptop and PS4 when they are connected to the switch together?
- By the way, if possible, could you please connect the switch to one of the satellite Decos to see whether all the 4 ports on the switch could get internet?
- And may I know the model number of your cable modem as well?
And we would like to follow up on your case by email as well and please have a check of your email box.
Thank you very much and wait for your reply.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 759
Replies: 3
Voters 0
No one has voted for it yet.