device not working as extender
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have configured this device as an extender by as soon as I switch on I am unable to browse even my normal network.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Good day, thank you very much for your time and patience.
Did you mean, after setting it up as the repeater mode, as soon as the device reboot, there Is no internet connection anymore?
Could you please check the IP address and default gateway when it is connected to the Wi-Fi of TL-MR3020?
And is the Wi-Fi name of TL-MR3020 the same as home router?
By the way, how long have you had the 3020?
Thanks a lot.
- Copy Link
- Report Inappropriate Content
Hi,
Thanks for your response
Yes, after configuring the 3020 on repeater mode and rebooted and then switching on the repeater , I am unable to browse. Although I can see the wifi bar and system is connected. If I switch off the repeater I can browse.
I understand that there is no need to make any changes in my IP address of the computer while using. Currently It is 192.168.0.11 when browsing the parent wifi.
Yes the wifi name configured in 3020 is same as parent wifi. My 3020 is about 4 years ols V2.
Regards,
Sandip
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 307
Replies: 2
Voters 0
No one has voted for it yet.