Manually choose which Deco to connect
Hello everyone,
I have 9pieces of Deco M5 inside of a house. After a new firmware arrived, I checked the map of my Deco M5 (how they're connected to each other) and notices, that some Decos bypassed 1 or 2 decos on their way and connected to the main Deco through wi-fi. There are 1 or 2 Decos between them, but they decided to connect to the Deco (main) which is far away from them.
I wonder why they choose to connect to him, when closer Decos avaialble ? Also would be great, if we can manually choose which Deco to connect to what Deco.
Thanks
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
I hope they change it. I have that problem on my deco x20 @Boriy
- Copy Link
- Report Inappropriate Content
Hi, Did you wish to manually choose the signal source of the satellite Deco or manually decide clients to connect which Deco units?
PS：
The original post is for Deco M5, and currently, there is already a firmware that supported these features:
- Copy Link
- Report Inappropriate Content
@TP-Link I have a similar issue where my M9 insists on connecting to the main Deco which is furthest and has the weakest signal. It bypasses the nearest M9 deco and as a result I am losing more than one-third of the speed. Is there a way for M9 Deco to manually choose which Deco to connect?
- Copy Link
- Report Inappropriate Content
@Vineet10 Nope. but they said they were going to roll out an update were you can select which deco is connected to which one.
- Copy Link
- Report Inappropriate Content
@Kevin_Z is your team reminded of this shitty problem??
or is your team being reminded only till now about this?????
- Copy Link
- Report Inappropriate Content
Hi, welcome to the community.
I can confirm we are aware of this issue and a new firmware will be planned to allow users to customize the signal source.
Do you have any specific problems when satellite Deco is not connected to the nearest unit, like slow speed or unstable connection?
- Copy Link
- Report Inappropriate Content
@Boriy I got the x20 and still cant choose manually the signal sources.
- Copy Link
- Report Inappropriate Content
@PabloMikael
yes, we need to wait for the next update, then we can change it.
- Copy Link
- Report Inappropriate Content
Same problem with my x60 system. Smart speaker upstairs showing unstable connection. On review it is connecting to deco downstairs when there is a unit in the same room upstairs. Need to switch connected deco for it to work.
- Copy Link
- Report Inappropriate Content
Hi, can you send an email to support.forum@tp-link.com with the following information:
1. what is the model number of your smart speaker?
2. is downstairs Deco the main Deco X60?
2. Please turn off the Mesh technology of smart speakers on the Deco APP and power cycle the smart speaker, and will it connect back to the nearest Deco?
Thank you very much.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 11
Views: 32764
Replies: 43
Voters 3
