@trioxify Please use the RE200's internal web management interface to setup the EasyMesh connection. The Tether app may not have been updated yet to reflect the features of firmware 1.0.23. There are...

@GennadijK87 I am not sure what would be the best way to contact them. Perhaps send an e-mail to one of their Technical Support addresses. https://www.realtek.com/Article/Index?menu_id=847&lang=en-GB

@Frog-1_2 Hi, "When I disconnect the ethernet cable from my computer only 2 green LEDs remain lit -- the powerline Network light and the power LED." -> This is how it should be. "However after about...

@trioxify Hi, According to the firmware update notes EasyMesh was added to the RE200 V5 in firmware version 1.0.23. https://www.tp-link.com/en/support/download/re200/v5/#Firmware Can you please post...

@beckkk Hi, Given the numbers you've posted I assume the two BE230 are connected to each other wirelessly (= wireless backhaul), not by Ethernet cable. According to its datasheet the RBK50 is a...

@tERROR Are you browsing to the web interface via tplinkwifi.net or via the router's actual IP address? In case it's the former, then check if using the IP address makes any difference. (e.g....