So - could you advise how I do these actions in Deco: Disable AP/Client isolation on your Access Point. There is no AP isolation for the main network of Deco and you don't need to worry about this...

@Fred.62 Yes, and you could need wire the EAP to Deco M5 via Ethernet cable.

@AlecFreddy63 Hi, Have you tried the suggestions of ImtiazAli? And after changing the QoS settings, if the speed is still capped to 100m/s, please leave me a private message for notification. Thank...

@BudNet Hi, Thank you for your feedback. I guess your modem here is Deco X60, right？ When Deco X60 was set up under access point mode and wired to Netgear Nighthawk Router, is the half-speed tested...

@srwzbk As mentioned in the solution, the half-speed over “Test Internet Speed” on the Deco APP under access point for Deco M5 will not affect the actual internet speed on the clients, which is what...

@Xijinping Hi, Nice to see you again. The further firmware will add a reboot schedule on the Deco and you could wait for the new firmware upgrade. Or before the release of official firmware, you...